Pipe threads where pressure-tight joints are made on the threads - Part 1: Dimensions, tolerances and designation
This Uganda Standard specifies the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads. These threads are taper external, parallel internal or taper internal and are intended for use with pipes suitable for threading and for valves, fittings or other pipeline equipment interconnected by threaded joints. This standard was PUBLISHED on 2011-12-20.
|Category||ENGINEERING AND CONSTRUCTION STANDARDS|
|TC||Petroleum Standards Technical Committee (UNBS/TC 16)|
|ICS||21.040.30 Special screw threads|
Cold rolled steel sections
Specification for steel pipes for water and gas suitable for scre ..
High-strength low-alloy Carbon Steel for hot rolled sheet and col ..
Hot-rolled, heavy-thickness carbon steel sheets, coils and strips ..
Cold reduced sheet of structural quality
Hot-rolled steel sections