US EAS 196:2013

High-strength low-alloy Carbon Steel for hot rolled sheet and cold rolled sheet - Specification


This Uganda Standard specifies the requirements for steel sheet in coils and cut lengths. It applies to the carbon steel and high-strength, low-alloy steel (HSLA) supplied as hot-rolled sheet and cold-rolled sheet. This standard is not applicable to hot-rolled, heavy-thickness carbon sheet coils. In case of any conflict in requirements, the requirements of the individual material specification shall prevail over those of the general specification. For the purposes of determining conformance with this specification and the various material specifications, values shall be rounded to the nearest unit in the right-hand place of figures used in expressing the limiting values. This standard was PUBLISHED on 2013-12-17.

This Standard was withdrawn and replaced by :

  US EAS 196:2022

Clients Who Bought This Standard also Bought:

US EAS 134:2013

Cold rolled steel sections

US ISO 7-1:2007

Pipe threads where pressure-tight joints are made on the threads

US 159:2000

Specification for steel pipes for water and gas suitable for scre ..

US EAS 108:2013

Hot-rolled, heavy-thickness carbon steel sheets, coils and strips ..

US 648:2006

Cold reduced sheet of structural quality

US ISO 657-1:1989

Hot-rolled steel sections

US ISO 657-2: 1989

Hot-rolled sections

US ISO 657-5:1976

Hot-rolled sections

Show Related Standards..