Low - voltage switchgear and control gear assemblies - Part 5: Particular requirements for assemblies intended to be installed outdoors in public places - cable distribution cabinets (CDCs) for power distribution in networks
This standard gives supplementary requirements for cable distribution cabinets (CDCs), which are stationary, type-tested assemblies (TTA) for outdoor installation in places which are exposed to the public, but where only skilled persons have access for their use. They are for use in public three-phase systems. This standard was PUBLISHED on 2006-11-14.
|Category||ENGINEERING AND CONSTRUCTION STANDARDS|
|TC||UNBS/TC 6-Electrotechnology Standards|
|ICS||29.130.20 Low voltage switchgear and controlgear|
Hot-dip galvanized plain and corrugated steel sheets - Specificat ..
Precast concrete paving units - Specification (2nd Edition)
Natural aggregates for concrete
Sand for construction - Specification
Cement Part 1: Composition, specification and conformity criteri ..
Specification for PVC conduits for electric wiring. Part 1: Plain ..
Polypropylene (PP) pipes - Dimensions
Standard specification for Electro technical, power, telecommunic ..
Steel for the reinforcement of concrete - Part 2: Ribbed bars (3r ..
Steel for the reinforcement of concrete - Part 1: Plain bars (3rd ..
Industrial standard for hot-dip zinc-coated steel sheets and coil ..
Roofing products from metal sheet - Fully supported products of s ..