Concrete pipes and ancillary concrete products - Part 3: Specification for unreinforced and reinforced concrete inspection chambers
This Uganda Standard specifies requirements and describes test methods for precast concrete inspection chambers, designed to be used for inverts not exceeding 2 metres deep, of circular, rectangular (with or without chamfered or rounded corners) or elliptical cross-section, unreinforced, steel fibre and reinforced, with nominal sizes or nominal lengths not exceeding DN 1250 or LN 1250, respectively. The intended use of this standard is to permit access to, and to allow aeration of, drain or sewer systems for the conveyance of sewage, rainwater and surface water under gravity or occasionally at low head of pressure, mainly installed in areas subjected to vehicular and/or pedestrian traffic. This part of US EAS 426 specifies complementary requirements to those in EAS 418 for unreinforced and reinforced concrete inspection chambers of circular and rectangular cross-section (with or without chamfered or rounded corners), as provided for in that standard. This part also specifies requirements for inspection chamber units less than or equal to DN 1000 or LN/WN1000/675 not exceeding 1 metre depth to invert. The inspection chambers are mainly intended for installation in areas outside the highway and where vehicle loading is restricted. This standard was PUBLISHED on 2020-06-16
Price | UGX 35,000/= |
---|---|
Category | ENGINEERING AND CONSTRUCTION STANDARDS |
Status | Voluntary |
Format | |
TC | UNBS/TC 3-Building and Construction Standards |
ICS | 91.140.80 Drainage systems |
Language | English |
Edition | 1st Edition |
Sales Rating |
Concrete pipes and ancillary concrete products - Part 1: Specific ..
Concrete pipes and ancillary concrete products - Part 2: Specific ..
Concrete pipes and ancillary concrete products - Part 4: Specific ..
Precast concrete pipes, fittings and ancillary products - Part 6: ..
Structural steels - Part 1: General technical delivery conditions ..
Structural steels - Part 2: Technical delivery conditions for str ..
Structural steels - Part 3: Technical delivery conditions for fin ..
Industrial standard for hot-dip zinc-coated steel sheets and coil ..